General Product Description
Dimension Range
Mechanical Properties
(mmin)
(mmin)
(min MPa)
(MPa)
(min %)
(mmin)
(mmin)
(min MPa)
(MPa)
(min %)
(mmin)
(mmin)
(min MPa)
(MPa)
(min %)
1) For transverse test pieces.
2) For both longitudinal and transverse direction.
Impact Properties
Charpy V 10x10 mm test specimen 1) 2)
1) Unless otherwise agreed, transverse impact testing according to EN 10025-6 option 30 will apply. For thicknesses between 6 - 11.9 mm, sub-size Charpy V-specimens are used. The specified minimum value is then proportrional to the cross-sectional area of the specimen compared to a full-size specimen (10 x 10 mm).
2) Other options are available after special agreement.
Chemical Composition (heat analysis)
(max %)
(max %)
(max %)
(max %)
(max %)
(max %)
(max %)
(max %)
(max %)
Carbon Equivalent CET(CEV)
Tolerances
Thickness
Tolerances according to EN 10029 Class A.
Length and Width
Tolerances according to EN 10029.
Shape
Tolerances according to EN 10029.
Flatness
Tolerances according to EN 10029 Class S (steel type H).
Surface Properties
According to EN 10163-2 Class A, Subclass 3.
Delivery Conditions
The delivery condition is Quenched and Tempered. The plates are delivered with sheared or thermally cut edges.
Fabrication and Other Recommendations
Welding, bending and machining
Welding, bending and machining recommendations can be found in brochures at www.raexsteel.com or consult Tech Support.
The properties of the delivery condition cannot be retained after exposure to temperatures in excess of 580ºC.
Appropriate health and safety precautions must be taken when welding, cutting, grinding or otherwise working on this product. Grinding, especially of primer coated plates, may produce dust with a high particle concentration.